Large-scale extrusion-based additive manufacturing of high-temperature resistant thermoplastic composites

Duchesne, O.; Verville, M.; Sojoudi Asli, N.; Auger, F.; Chizari, K.; Farahani, R.; Gosselin, F.P.; Therriault, D. (2026). Large-scale extrusion-based additive manufacturing of high-temperature resistant thermoplastic composites. Additive manufacturing, 2026, vol. 131, 105412.

 

Additive manufacturing (AM) by material extrusion of high-temperature resistant reinforced thermoplastics offers new design possibilities for large-scale aerospace structures, where production volume is low and mechanical requirements are high. To fill the need for a manufacturing method to make a complex lunar rover frame, we demonstrate by Fused Filament Fabrication (FFF) the rapid large-scale manufacturing of carbon fiber-reinforced polyether ether ketone (CFR-PEEK) composite structures featuring a variable sandwich panel core thickness and an optimized cellular distribution using a custom printing infrastructure. To achieve this main objective, we first determined the appropriate printing parameters from CFR-PEEK flexural beam specimens printed at various combination of nozzle temperature and printing speed. The highest apparent flexural modulus of 9.4 GPa and the highest apparent flexural strength of 220 MPa were achieved using a nozzle temperature of 440 °C and a nozzle motion speed of 50 mm/s. The best set of parameters also yielded the lowest porosity content of 2% interbead and 10% intrabead. Using the previously determined printing parameters, we compared the shear strength of three types of sandwich panels: fully printed panels, hybrid panels (printed core bonded to continuous CFR-polyaryl ether ketone (PAEK) facesheets), and a benchmark panel with a nomex® honeycomb core bonded to the same PAEK facesheets. Although the specific ultimate shear strength of the hybrid panels in the honeycomb configuration is 4.6 times lower than that of the nomex® honeycomb core, the proposed method enables the fabrication of larger cores in a single process, with the capability for graded structures. The implementation of large-scale CFR-PEEK structures could find applications in the aerospace field, where mass reduction of complex geometries is critical for mission success.